Renault K9K - Exhaust Manifold - Intake Distributor: Removal - Refitting

12A-34
FUEL MIXTURE
Exhaust manifold - Intake distributor: Removal - Refitting
F9Q
12A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine cover,
-the engine undertray bolts,
-the engine undertray,
-the battery (see Battery : Removal - Refitting)
(80A, Battery),
-the battery tray (see Battery tray: Removal - Re-
fitting) (80A, Battery),
-the windscreen wiper arms (see Windscreen wi-
per arm: Removal - Refitting) (85A, Wiping -
Washing),
-the scuttle panel grille (see Scuttle panel grille:
Removal - Refitting) (56A, Exterior equipment),
-the scoop under the scuttle panel grille (see Scoop
under scuttle panel grille: Removal - Refitting)
(56A, Exterior equipment),
-the intercooler air inlet pipe (see 12B, Turbochar-
ging, Intercooler air inlet pipe: Removal - Refit-
ting, page 12B-41) ,
-the turbocharger outlet exhaust gas duct (see 12B,
Turbocharging, Turbocharger outlet exhaust
gas duct: Removal - Refitting, page 12B-49) ,
-the exhaust gas recirculation assembly (see 14A,
Antipollution, Exhaust gas recirculation as-
sembly: Removal - Refitting, page 14A-18) ,
-the lower engine tie-bar (see 19D, Engine moun-
ting, Lower engine tie-bar: Removal - Refitting,
page 19D-33) ,
-the turbocharger (see 12B, Turbocharging, Tur-
bocharger: Removal - Refitting, page 12B-8) .
a Remove the bolts (1) from the inlet manifold air inlet
pipe.
a Remove:
- the bolts (2) from the turbocharger control solenoid
valve,
- the turbocharger control solenoid valve,
- the bolts (3) from the exhaust manifold heat shield,
- the exhaust manifold heat shield.
Tightening torquesm
exhaust manifold - inlet
manifold nuts
33 N.m
bolts on the right-hand
lifting eye
25 N.m
inlet manifold air inlet
pipe bolts
25 N.m
137475
137476