Renault K9K - Refitting

10A-64
ENGINE AND CYLINDER BLOCK ASSEMBLY
Oil pressure sensor: Removal - Refitting
K9K
10A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine undertray bolts,
-the engine undertray.
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Disconnect the oil pressure sensor connector (1) .
a Remove the oil pressure sensor using the (Mot.
1495).
REFITTING
I - REFITTING PREPARATION OPERATION
a Wipe any oil run-off with a cloth.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the oil pressure sensor using the (Mot. 1495).
a Connect the oil pressure sensor connector.
III - FINAL OPERATION
a Refit the engine undertray.
Essential special tooling
Mot. 1495 22 mm oxygen sensor remo-
val/refitting socket - 1/2"
square drive and a 24 mm
Allen key.
123835