E1/E20/E2/E2 Lite Additional Document 2. Designing the User System
R20UT2937EJ0301 Rev.3.01 Page 20 of 45
Jul 1, 2020
2.5 Notes on Connection
Wiring patterns between the connector and the MCU must be as short as possible (within 50 mm is
recommended). Do not connect the signal lines between the connector and MCU to other signal lines on
the board.
For the handling of pins while the E1/E20/E2/E2 Lite is not in use, refer to the hardware manual for the
MCU.
To Next Page
Loading...
