E2 Lite Appendix A
R20UT3240EJ0300 Rev.3.00 Page 30 of 36
May.15.20
If the user-system interface cable is connected to the emulator when you click on the [OK] button, “FAIL”
is displayed on the screen (see the figure below). Disconnect the user-system interface cable from the
emulator and click on the [START] button again to start the SCP.
Figure A.3 [FAIL] at the Start of Self-Checking (when the User-System Interface Cable is Connected
to the Emulator)
To Next Page
Loading...
