Renesas RA4 Series - PMOD A Connector Details; PMOD B Connector Details; User Capacitive Touch Button Circuit

Renesas RA Family EK-RA4M2 – Quick Start Guide
R20QS0018EG0100 Rev.1.00 Page 9 of 29
Jan.04.21
4. Running the Quick Start Example Project
This section lists the requirements and instructions to power up the EK-RA4M2 board and run the Quick
Start example project.
Hardware Requirements
• EK-RA4M2 board
• Micro USB device cable
• A PC with at least 1 USB port
Software Requirements
• Windows
®
10 operating system
• USB Serial Drivers (included in Windows 10)
• TeraTerm (or similar) terminal console application
4.1 Connecting and Powering Up the EK-RA4M2 Board
1. Check that J12 is set to link pins 2-3. And that J15 link is closed.
2. Connect the micro USB end of the micro USB device cable to micro-AB USB Full Speed port (J11) of the
EK-RA4M2 board.
3. Connect the other end of this cable to the USB port of the host PC. Power LED (LED4) on the EK-
RA4M2 board lights up white, indicating that the EK-RA4M2 board is powered on.
Note: If the EK-RA4M2 board is not powered through micro-AB USB Full Speed port (J11) and the host
PC, then USB CDC functionality of the Quick Start example project cannot be fully demonstrated
because of the absence of a USB Full Speed Device connection with the host PC.
Figure 3. Connecting the EK-RA4M2 Board to the Host PC via USB Full Speed Port