Renesas RH850/U2A 292pin - Connectors Overview

RH850/U2A 292pin 2. Jumpers, Connectors and LEDs
R20UT4545ED0102 Rev.1.02 Page 15 of 58
May 27, 2021
2.2 Connectors Overview
The following table provides an overview of all connectors.
Table 2.2 Connectors overview (cont'd)
Connector
Function
Remark
CN1
Main Board connectors
refer to 7.1 Connectors to the Main Board CN1
to CN3
CN2
CN3
CN4
Debug connector
refer to 5 Debug and Flash Programming
Interfaces and 7.2 Debug Connector CN4
CN5
RHSIF & MSPI connector
refer to 6.6 Renesas High-Speed Serial I/F
(RHSIF) / Multichannel Serial Peripheral
Interface (MSPI) and 7.3 RHSIF/MSIP
Connector CN5
CN6
Ethernet interface connector
refer to 6.5 Automotive Ethernet Interface and
7.6 Ethernet Connector CN6 and CN17
CN7
Signaling LEDs pin header
refer to 6.3 Signaling LEDs
CN8
GND for external power supply
refer to 3.1 Board Power Connection,
connectors are not assembled on the board
CN9
+5.0 V external power supply
CN10
+3.3 V external power supply
CN11
+1.12 V external power supply *
CN12
Pull-up/Pull-down pin header
refer to 6.4 Pull-Up/Pull-Down Pin Header and
7.5 Pull-Up/Pull-Down Pin Header CN12
CN13
Device ports connectors
refer to 7.4 Device Ports Connectors CN13 to
CN16
CN14
CN15
CN16
CN17
Ethernet interface connector
refer to 6.5 Automotive Ethernet Interface and
7.6 Ethernet Connector CN6 and CN17
CN20
GPIO/LED output
Refer to 7.7 GPIO/LED Connector CN20
Note: * Refer to 3.3 Device Core Voltage (VDD) Selection for further details about VDD voltage.