RH850/U2A 292pin 1. Overview
R20UT4545ED0102 Rev.1.02 Page 10 of 58
May 27, 2021
1.5 Mounting of the Device
The board is designed for use with the following devices:
• R7F702300EABA (RH850/U2A16)
• R7F702301EABG (RH850/U2A8)
The device must be placed inside the socket IC1. To insert the device, align the device package A1 pin with the marking
of the socket.
The A1pin of the socket is marked with a circle near to the “IC1” label (see also white point in Figure 1.1 Piggyback
board top view).
The A1 pin of the device is marked by a white triangle on the package (see white circle in the figure below).
CAUTION
Be careful with the device placement in the socket to avoid damage of the device.
To Next Page
Loading...
