Renfert SILENT EC2 - Initial Operation

EN
3 On / Off switch
 Menu key
 Symbol self-diagnosis
 Symbol acoustic signal
 Symbol dust drawer full
 Set the switch-on threshold
 Set the after-run time
 7-segment display
 Display of the suction levels
 Suction channel indicator
 Suction channel keys
 Enter key, save input / display enter key
31 [-] key / display function of the [-] key
 Display Factory setting
33 [+] key / display function of the [+] key
34 Cover (do not remove, service interface)
Initial Operation
Setting-up
The suction unit is a standing device which must not be operated in a horizontal position.
 *GUIFTVDUJPOVOJUJTQMBDFEJOBDMPTFEDBCJOFUUIFXBSNFYIBVTUBJSNVTUCFUSBOTQPSUFEPVUPG
UIFDBCJOFUVTJOHPOFPGUIFNFBTVSFTTIPXOJO'JHT"#$BUUIFTUBSUPGUIJTNBOVBM
A: External ventilation duct (see accessories at www.renfert.com).
%2EVHUYHWKHRSHQLQJLQWKHFDELQHWVSHFL¿HGPHDVXUHPHQWVPLQLPXPDQGPD[LPXPGLVWDQFHV
C: Remove the back side of the cabinet, the distance from the back side of the cabinet to the wall
min. 50 mm.
Connect
 Connect to the compressed air supply system, using a connection kit if necessary (14).
 $PNQSFTTFEBJSTIPVMECFDMFBOBOEESZXJUIPVUDPOEFOTFEXBUFS8FUDPNQSFTTFEBJSDBO
EBNBHFUIFVOJU
 8BSOJOHSJTLPGJOKVSZ
8IFOTIPSUFOJOHUIFTVDUJPOUVCFQMFBTFCFTVSFUPDVUUIFJOUFHSBUFEXJSFBTTUSBJHIUBTQPTTJ
CMF
 -POHTVDUJPOUVCFTUJHIUCFOETBOELJOLTHSFBUMZSFEVDFUIFTVDUJPOQPXFSBUUIFTVDUJPOQPJOU
 Shorten the suction tubes to the required length for both suction points.
 6FUHZWKHHQG¿WWLQJVRQWRWKHVXFWLRQWXEHVOHIWWXUQWKUHDG
 Place the suction tube onto the suction port (6A / 6B).
Observe the allocation of the device sockets (A, B) – suction channel (A, B).
 Connect the suction tube to the correct suction point.
 *GUIFEJBNFUFSJTOPUTVJUBCMFVTFBOBEBQUFSTFFBDDFTTPSJFTUPBWPJEMPTTPGTVDUJPO
 Connect the electrical equipment to the device sockets (8A / 8B) on the back.
Observe the allocation of the device sockets (A, B) – suction channel (A, B).
 8IFODPOOFDUJOHUIFFMFDUSJDBMFRVJQNFOUUPUIFTVDUJPOVOJUFOTVSFUIBUUIFTVNPGUIFFMFDUSJ
DBMQPXFSGSPNUIFDPOOFDUFEFMFDUSJDBMBQQMJBODFTEPFTOPUFYDFFEUIFNBYJNVNQFSNJTTJCMF
UPUBMQPXFSTFFߧ5FDI%BUBߨBUUIFFOEPGUIJTEPDVNFOU
 Switch the device off at the on / off switch (3).
 Unroll the mains cable (9) and insert the plug into the building’s electrical socket.
See Fig. 2 (on inside cover)
- 3 -