Renfert SILENT EC2 - Page 13

EN
6HOIGLDJQRVLVVHH)LJ'DWWKHVWDUWRIWKLVPDQXDO
Start the self-diagnosis manually. This is performed once.
$FRXVWLFVLJQDOVHH)LJ'DWWKHVWDUWRIWKLVPDQXDO
:KHQVZLWFKHGRQYDULRXVVHWWLQJVZLOOEHFRQ¿UPHGZLWKDQDFRXVWLFVLJQDO
7LPH,QWHUYDOIRU³)XOO´'LVSOD\'XVW'UDZHUVHH)LJ'DWWKHVWDUWRIWKLVPDQXDO
After reaching a set time interval, a request appears to empty the dust drawer.
You can select between 5 times.
Time interval / hrs 9DOXHLQGLVSOD\
2 1
5 2
10 3
50 4 Factory setting
100 5
 8JUIEFWJDFTXIJDIHFOFSBUFMBSHFBNPVOUTPGEVTUFHTBOECMBTUJOHVOJUTUIFUJNFJOUFSWBM
ߧFNQUZEVTUESBXFSߨTIPVMECFTFUUPIPVSTJGOFDFTTBSZUPIPVST
6ZLWFKRQWKUHVKROGIRUDXWRPDWLFRSHUDWLRQVHH)LJ(DWWKHVWDUWRIWKLV
PDQXDO
The switch-on threshold, when a connected electrical device opens the suction channel, can be individu-
ally set for each suction channel.
:KHQVHWWLQJWKHVZLWFKRQWKUHVKROGIRUKDQGSLHFHVIRUWKH¿UVWPHDVXUHPHQW2))WKHFRQWUROXQLW
must be switched on without operating the handpiece.
In the second measurement (ON), handpieces should be operated at the speed at which the suction is to
be switched on.
 %FWJDFTXJUIBTUBOECZNPEFTIPVMECFTXJUDIFEPOBQQSPYNJOVUFTCFGPSFTFUUJOHUPBWPJE
JODPSSFDUNFBTVSFNFOUT
 *GUIFSFJTBOFSSPSXIFOTFUUJOHUIFTXJUDIPOUISFTIPMEUIFEJTQMBZXJMMCMJOLߧ$BMߨBOEB
YBDPVTUJDTJHOBMJTFNJUUFE$BSSZPVUUIFTFUUJOHBHBJO'PSIBOEQJFDFTTFMFDUBIJHIFSTQFFE
JGOFDFTTBSZ4FFBMTPߧ&MJNJOBUFGBVMUTߨJOUIFDPNQMFUFPQFSBUJOHJOTUSVDUJPOTXIJDIZPVDBO
EPXOMPBEGSPNPVSXFCTJUFBUXXXSFOGFSUDPNQ
$IWHUUXQ7LPHRIWKH6XFWLRQ7XUELQHVHH)LJ(DWWKHVWDUWRIWKLVPDQXDO
After-run time = The period of time between switching a connected device off and the closing of the corre-
sponding suction channel (= pinch valve).
A distinction is made between three after-run times, which can be set independently of one another
(factory setting: 3 seconds):
• After-run time suction channel A Î only suction channel A is open:
Time, until the pinch valve of suction channel A closes and the suction turbine switches off.
• After-run time suction channel B Î only suction channel B is open:
Time, until the pinch valve of suction channel B closes and the suction turbine switches off.
• After-run time suction channel A and B Î both suction channels, A AND B, are open:
Time, until the pinch valve of a suction channel closes and the suction performance for the other suction
channel is adjusted.
 *OPSEFSUPQSFWFOUUIFTVDUJPOGSPNCFJOHTXJUDIFEPOPGGUPPPGUFOPSUIFTVDUJPOQFSGPSNBODF
UPCFBEKVTUFEUPPGSFRVFOUMZJOUIFDBTFPGTIPSUJOUFSSVQUJPOTGPSFYBNQMFXIFOXPSLJOHXJUI
UIFIBOEQJFDFBIJHIFSUJNFWBMVFTIPVMECFTFMFDUFE
The setting after-run time can be exited at any time before or after saving the entered value via the Menu
key (20).
- 5 -