23
3. Tap the Parameter Setting Key to select the Boost charge voltage.
Use the Page Up/Down keys to select your desired voltage.
4. To confirm, hold down the Parameter Setting Key for approximately
2-3seconds. The screen will clear and revert to the House Battery
Voltage.
Setting Lithium
1. Use the Page Up/Down key to show the Voltage Interface.
Hold down Parameter Setting Key for approximately 2-3seconds
and the top line will begin flashing the battery type.
2. Use the Page Up/Down to highlight Li (Lithium).
1.Hold Param. Setting
key for 2-3s until flashing
3.Use Up/Down keys to
highlight Boost Voltage
4.Confirm setting by
holding Param. Setting key
for 2-3s
2.Use Up/Down keys to
highlight Lithium “Li”, then
Tap Param. Setting key
To Next Page
Loading...
