Reolink E1 Zoom User Manual

Reolink Wireless Camera
User Manual
6
2. Setup and Installation
Set up the Camera
Set up the Camera Without Ethernet port
Please follow the steps below to do initial setup for the WiFi cameras without an
Ethernet port via the Reolink App.
1. Connect the power adapter to the camera and wait for it starting up. After
hearing a startup sound, you will hear repeated Ding sounds or "Please run Reolink
App, add the camera and set it up", which means you can scan the QR code on the
camera and start the setup process.
Note:
If you are not sure whether you hear the right sound, you may tap "Demo" to hear
the sample sound. If you couldn't hear the repeated Ding sounds, please reset your
camera.
2. Tap on the icon in the top right corner to start the initial setup.

Reolink E1 Zoom Specifications

General

Sensor type	CMOS
Number of sensors	1
Optical sensor size	1/2.7 \
Total megapixels	5 MP
Maximum resolution	2560 x 1920 pixels
Video compression formats	H.264
Optical zoom	3 x
Zoom capability	Yes
Focal length range	2.8-8 mm
Maximum aperture number	1.6
Type	IP security camera
Placement supported	Indoor
Connectivity technology	Wireless
Pan range	0 - 355 °
Tilt angle range	0 - 50 °
Minimum illumination	0 lx
LED type	IR
Infra-red wavelength	850 nm
Night vision distance	12 m
Number of illumination LEDs	10
DC output current	1 A
DC output voltage	5
Power source type	DC
Compatible memory cards	MicroSD (TransFlash)
Audio system	2-way
Bluetooth	No
Number of users	20 user(s)
Networking standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Supported network protocols	HTTPS, SSL, TCP/IP, UDP, HTTP, IPv4, UPnP, RTSP, RTMP, SMTP, NTP, DHCP, DNS, DDNS, FTP, P2P
Security algorithms	WPA-PSK, WPA2-PSK
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-10 - 55 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	20 - 85 %
Form factor	-
Mounting type	Ceiling/wall
Product color	White

Weight and Dimensions

Height	111 mm
Weight	250 g
Diameter	80 mm