HOME SLEEP TESTING DEVICE INSTRUCTIONS
If you have a Medical Emergency, call 911.
If you have technical questions during your test, please call Sleep Insights: 585.385.6070, option 4
If calling during regular business hours, select option 0 and ask for Home Sleep Study technical support.
NOTE: If there is no answer, the sleep technician may be with a patient. Please leave a voicemail.
Calls are typically returned within 20 minutes.
GETTING STARTED
There are four main steps to setting up and completing your Home Sleep Test (HST):
1. FITTING THE HST DEVICE
2. STARTING THE TEST
3. STOPPING THE TEST
4. DISASSEMBLING AND RETURNING THE HST DEVICE
Before fitting, set out all the system components and read these instructions first.
NOTE: Wear Apnea Link Air and belt over pajamas or nightshirts with long sleeves to avoid any
discomfort from the belt.
Instructional video at https://www.youtube.com/watch?v=awa4z2fFn7A
1. FITTING:
Pull the belt around your body.
Thread the end of the belt through
the slot on the effort sensor (if used)
and fasten the tab to the belt. If you
are not using the effort sensor,
attach the tab to the belt.
Check that the belt is secure and
comfortable and that the device is
positioned over the center of your
chest.
If using an oximeter, slide the clip
onto the belt. The clip should be
worn on the same side of your
body as the oximeter finger.
To Next Page
Need help?
General
