Reassembling the H5i
When all the parts are clean and dry, reassemble the H5i as follows:
1. Reinsert the air outlet ensuring that the straight side is facing up.
2. Place the outlet clip back onto the air outlet. Ensure that the outlet clip goes past the ridge on the
air outlet.
3. Reinsert the maximum water level mark into the plate ensuring that it clicks into place.
4. Place the plate back onto the base ensuring that the maximum water level mark faces up.
5. Place the tub lid back onto the plate/base ensuring that the centre holes are aligned.
6. Clip all four side latches.
7. Fill the water tub and return the water tub to the H5i.
8. Close the flip lid ensuring that it clicks into place.
Packaging and storage
Store in a dry, dust-free environment away from direct sunlight.
Storage temperature: -20°C to 60°C.
ResMed Ltd
1 Elizabeth Macarthur Drive
Bella Vista NSW 2153 Australia
DISTRIBUTED BY
ResMed Corp 9001 Spectrum Center Boulevard San Diego CA 92123 USA
ResMed (UK) Ltd 96 Jubilee Ave Milton Park Abingdon Oxfordshire OX14 4RW UK
See www.resmed.com for other ResMed locations worldwide. For patent and other intellectual property information, see www.resmed.com/ip. H5i is a trademark of
ResMedLtd. CIDEX and Sterrad are trademarks of Johnson & Johnson. Alconox is a trademark of Alconox Inc. Neodisher MediZym is a trademark of Chemische Fabrik
DrWeigert. Aniosyme and Anioxyde are trademarks of Laboratoires Anios. Sekusept is a trademark of Ecolab. © 2014 ResMed Ltd. 368960/1 2014-12
ResMed.com
To Previous Page
Loading...
Need help?
General
