18
this may damage the radio and may also cause you to exceed RF
exposure limits. A proper antenna is the antenna supplied with this
radio by the manufacturer or an antenna specifically authorized by
the manufacturer for use with this radio, and the antenna gain shall
not exceed the specified gain by the manufacturer declared.
• DO NOT transmit for more than 50% of total radio use time, more
than 50% of the time can cause RF exposure compliance
requirements to beexceeded.
• During transmissions, your radio generates RF energy that can
possibly cause interference with other devices or systems. To avoid
such interfere-nce, turn off the radio in areas where signs are
posted to do so.
• DO NOT operate the transmitter in areas that are sensitive to
electromagnetic radiation such as hospitals, aircraft, and blasting
sites.
• Portable Device, this transmitter may operate with the antenna(s)
documented in this filing in Push-to-Talk and body-worn
configurations. RF exposure compliance is limited to the specific
belt-clip and accessory configurations as docum-ented in this filing
and the separation distance between user and the device or its
antenna shall be at least 2.5 cm.
• Mobile Device, during operation, the separation distance between
user and the antenna subjects to actual regulations, this separation
distance will ensure that there is sufficient distance from a properly
installed externally-mounted antenna to satisfy the RF exposure
requirements.
• Occupational/Controlled Radio, this radio is desig-ned for and
classified as “Occupational/Controlled Use Only”, meaning it must
be used only during the course of employment by individuals aware
of the hazards, and the ways to minimize such hazards; NOT
intended for use in a General population/uncontrolled environment.
• General population/uncontrolled Radio, this radio is designed for
and classified as “General population/uncontrolled Use”.
RF Exposure Compliance and Control Guidelines
and Operating Instructions
To Next Page
Loading...
