What to do if I hear other conversations on my Retevis Two-Way Radio?
If you are hearing conversations from outside your group on your Retevis Two-Way Radio, you should change your code settings. Ensure that all Two-Way Radios in your group are updated with the new settings.
Why my Retevis RT10 Two-Way Radio has no power?
If your Retevis Two-Way Radio has no power, the battery may have run out. Please update or recharge the battery. Also, the battery may not be properly installed. Please take it off and reinstall it.
Why does the battery on my Retevis Two-Way Radio last a short time?
If your Retevis Two-Way Radio's battery life is short after charging, the battery life is over, please replace it with a new one.
What to do if Retevis RT10 Two-Way Radio transceiver continues to tweet?
If your Retevis Two-Way Radio transceiver continues to tweet, the channel is empty. Turn on another channel or use it after writing frequency by program software.
General| Channel Capacity | 16 |
|---|---|
| Antenna Impedance | 50Ω |
| RF Power Output | 5W |
| Modulation | FM |
| Frequency Range | UHF 400-470MHz |
| Operating Voltage | 3.7V |
Details on initial charging, capacity, and performance optimization for the battery.
Instructions for attaching and detaching the battery pack from the transceiver.
Procedure for securely attaching the antenna to the top of the transceiver.
Steps for installing or removing the belt clip using supplied screws.
Guide on how to attach the hand strap to the middle loop of the transceiver.
Details the functions and factory default settings of Side Key 1 and Side Key 2.
Procedure for turning the transceiver on and off using the power knob.
How to increase or decrease the audio volume using the power/volume knob.
Method for selecting desired channels using the channel selector knob.
Explains the meaning of the LED indicator lights for transceiver status.
Describes the operation of the Push-to-Talk (PTT) key for transmitting and receiving.
Outlines how to receive and transmit calls, including zone selection.
Details procedures for receiving and replying to individual and group calls.
Explains how to receive calls from a user's designated group.
Describes how to receive one-to-one calls, including detection methods.
Explains how to receive broadcast calls to all transceivers on a channel.
Details methods for initiating group and individual calls via channel selection.
Guides on initiating calls to a specific group using channel and group ID.
Provides steps for initiating one-to-one calls using channel and group ID.
Explains how to set up encryption for digital mode using preset groups or keys.
Details how to adjust the squelch level to filter unwanted calls or background noise.
Covers radio licensing, unauthorized modifications, and compliance with FCC, CE, and IC regulations.
Details RF exposure, safe usage, hearing protection, burn hazards, and battery safety precautions.
Lists conditions for safe operation, including aircraft use and avoiding hazardous environments.
To Next Page
