Insert the top part of the battery pack into the top 2 slots of the
transceiver and then button the bottom's buckle . (1)
To remove the battery pack, make sure the transceiver has
been turned off, and then open the bottom's buckle,Remove the
battery when the batter pops up. (2)
Install Antenna
Hold the base of antenna, rotate it tightly into the connector of the
top of transceiver clockwise. (3)
Install/Remove Belt Clip
If necessary, install the supplied screws into the belt clip at the back
of battery pack for easy carry.
To remove the belt clip, directly remove the two screws only. (4)
Install Hand Strap
Install the hand strap at the middle circle of the transceiver. (5)
04
(3) (4) (5)
(1) (2)
To Next Page
Loading...
