11
Launch All Call
This functions allows you to transmit to all users in same
channel. The transceiver must be programmed with this function,
so that you can send information to every user who are under
the channel.
1.Rotate channel knob, using activated all call group ID to select
channel.
2.Hold the transceiver vertically and keep about
1~2inches(2.5-5.0cm) away from mouth.
3. Press PTT key to respond the call, LED indicator turns red.
Encryption Function
Encryption Setting (This function is effective for digital
mode only)
According to the programming software setting, there are 10
groups at most to preset group encryption or encryption key (10
Byte) With pre-programmed key to start up / shut down encryp-
tion function.
Setting
Setting Squelch level
You can adjust the transceiver squelch level, filter low signal
strength(unwanted calls) or the the channel of background noise
is higher than the channel common values.
Set: 1-10 levels,the higher the level, the deeper the squelch,
squelch deep filtration (unwanted) calls or background noise.
However, a call from a remote location may be also filtered out.
To Next Page
Loading...
