07
Basic Operations
POWER ON and POWER OFF:
Rotate the knob clockwise until a
“click” is heard, transceiver will
have a short beep sound, indicating
power on detecting success.
Attention:
If your transceiver is not power on,
please check the battery, and confirm
if the battery has been charged and
installed correctly. If it still can not be turned on, please contact
with the agent.
To turn off the transceiver, please rotate the power knob /
Volume knob anticlockwise until a “click” is heard, then
transceiver is power off.
Adjust Volume
When the transceiver is power on,
rotate the power switch / Volume
knob to adjust the volume. Clockwise
rotation to increase the volume;
Anticlockwise rotation to decrease the
volume. You can press the side key
which is programmed MONITOR
function to monitor the current volume.
Attention:
MONITOR key can be set to P1 or P2 Key according to the
programming software.
Channel Selection:
Rotation the channel knob to select
the desired channel. This transceiver
has 128 channels.
Attention:
There are eight zones in this transceiver,
To Next Page
Loading...
