Retevis RT69 - Page 11

19
Tips:
If transmit time continuous exceed “overtime alarm”, error voice then stop transmit.
Press [MENU] enter, press [UP]/[DOWN] choose time, then press [MENU] confirm, final press [EXIT] back to standby.
Transmit overtime alarm have 10 seconds, total is 10 level, each level 1 second. Off: close the over time alarm.
Beep (BEEP)---Menu 11
In the standby states, press [1 STEP][1 STEP], LCD Display:
Press [MENU], then Press [UP]/[DOWN] to select ON/OFF, and press [MENU]to confirm, final press [EXIT] back
to standby.
Screen English(LANGUAGE )---Menu 12
In the standby, press [MENU]+[1 STEP][2 SQL], LCD Display:
Press [MENU], then Press [UP]/[DOWN] to select language, and press [MENU]to confirm, final press [EXIT] back
to standby.
The radio only 1 language display: ENGLISH
Busy channel lock-out (BCL)---Menu 13
BEEP
LANGUAGE
20
Tips:
when radio working under the mode of cross band repeater and transmit , this is function is prohibit.
Tips:
Press [*SCAN] with 2 second, then can enter into scanning states.
BCL
SC-REV
R-CTC
In the standby, press [MENU]+[1 STEP][ 3 SAVE], LCD Display:
Press [MENU], then Press [UP]/[DOWN] to select ON/OFF, and press [MENU] to confirm ,final press [EXIT] back
to standby.
Scan mode (SC-REV) ---Menu 14
In the standby, press [MENU]+[1 STEP][4 TXP], LCD Display:
Press [MENU], then press [UP]/[DOWN] to select scan mode, and press [MENU] to confirm, final press [EXIT] back
to standby.
To: scanning the carrier signal, and not any operation within 5 seconds will continue to scan.
CO: scanning the carrier signal will stop scanning, carrier signal will disappear after 3 seconds then continue to scan.
SE: scanning the carrier signal will stop scanning.
Receiving CTCSS(R-CTC) ---Menu 15
In the standby, press [MENU]+[1 STEP][5 ROGER], LCD Display: