33
Tips:
Every radio only have one unique ANI code, A area /B area editing are the same ANI code.
Tips:
The radio ANI code Side Tone like below.
DT-ST: Opening Keyboard Side Tone when transmitting.
ANI-ST: Opening ANI code side tone when transmitting.
DT+ANI: Opening the side tone of keyboard and ID code when transmitting.
DTMF-ST
AUTOLOCK
ANI code side tone (DTMF-ST) ---Menu 34
In the Standby, press [MENU]+[3 SAVE][4 TXP], the screen displays:
Press [MENU] to Enter, Press [UP/DOWN] to select the ID Side Tone you need, then press [MENU] to confirm, and
press [EXIT] back to standby.
Automatic keyboard lock setting (AUTOLOCK) ---Menu 35
In the Standby, press [MENU]+[3 SAVE][5 ROGER], the screen displays:
Press [MENU] to Enter, Press [UP/DOWN] to select ON/OFF, then press[MENU]to confirm, and press[EXIT] back
to standby.
After the automatic lock is ON, The keyboard will automatic lock Within 15 seconds when radio have not any
34
Tips:
Manual Lock: In the standby, Press hold [#LOCK] for 2seconds or more and will be locked, then hold
[#LOCK] for 2seconds or more and will be unlocked.
PRI CH-SW
operation , please hold [#LOCK] for 2seconds or more and will be unlocked.
Priority channel switch setting (PRI CH-SW) ---Menu 36
In the Standby, press [MENU]+[3 SAVE][6 TOT], the screen displays:
Press [MENU] to Enter, Press [UP/DOWN] to select ON/OFF, then press[MENU]to confirm, and press [EXIT] back
to standby.
Sometimes it needs check some activity of priority frequency while monitoring other frequency. Then you can use
priority scanning function.
Ex: Scanning 6 common channel CH1、CH2、CH3、CH4、CH5、CH6, and Ch6 will be set to priority channel.
The scanning process CH1→CH6→CH2→CH6→CH3→CH6→CH4→CH6→CH5→CH6.
If the radio detects a signal on the "priority channel", it will call-up this frequency; it can go ahead select the priority
channel through our software.
Repeater setting (RPT-SET) ---Menu 37
To Next Page
Loading...
