37
RPT-SET
switch settings, select the audio conversion receiver and transmitter speaker is open the machine according to
whether to support the [PTT] in transit or relay transmission. However, the signal will be temporarily interrupted
when PTT is transmitted.
In the standby, press [MENU]+[3 SAVE][7 VOX], the screen displays:
Press [MENU] to enter, press [UP] / [DOWN] keys to select the desired parameter press [MENU] to confirm.
The RPT key on the speaker and repeater mode to switch on the waiting state, long press [RPT] 2
second can realize conversion between speaker and repeater mode.
Under the mode of directional/dual cross band repeater, the screen display
In order to use the repeater platform repeater receipt sound can be timely and effectively reflect the repeater
state of the work, improve the use efficiency of the simulator, you can use the menu function [47] to set.
Keep the timer relay to prevent hand response messages and communication have been repeatedly press
and release the button. When the mobile receiver release button, "holding time " allows the hand while
waiting for the moment to launch in response to user. If the QT/DQT is not detected during the duration of
the hold time, the transmitter is allowed to release the key. This parameter determines that the duration of
the state of the key is maintained when the valid QT/DQT receiver signal disappears. The function may
be set by our company to write software.
Notice:
38
Tips:
The radio working under the cross band repeater or repeater /Transmitting mode, this function is prohibited.
RPT-SPK
RPT-PTT
Repeater speaker setting (RPT-SPK) ---Menu 38
In the standby, Press [MENU]+[3 SAVE][8 W/N], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select ON/OFF, then Press [MENU] to confirm, and Press [EXIT]
back to standby.
Repeater PTT setting (RPT-PTT) ---Menu 39
In the standby, Press[MENU]+[3 SAVE] [9 VOICE], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select ON/OFF then Press [MENU] to confirm, and Press [EXIT]
back to standby.
Scan Add setting (SCAN-ADD)---Menu 40
SCAN-ADD function can only be set in the channel mode, the current channel can be set, the frequency mode
settings are invalid.
In the standby, Press[MENU]+[4 TXP][ 0 ], the screen display
Press [MENU] to enter, Press[UP]/[DOWN] to select ON/OFF then Press[MENU] to confirm, and Press [EXIT]
back to standby.
The radio working under the cross band repeater or repeater /Transmitting mode, this function is prohibited.
SCAN-ADD
To Next Page
Loading...
