Retevis RT69 - Page 21

39
Single tone pulse frequency (ALERT)---Menu 41
In the standby, Press [MENU]+[4 TXP][1 STEP], the screen display
Press [MENU] to enter, Press [UP]/ [DOWN] to select the need parameter then Press [MENU] to confirm, and
Press [EXIT] back to standby.
In launching state by pressing the side button PF2, the selected tone pulse frequency to send out.
ANI code transmission delay setting (PTT-DLY)---Menu 42
In the standby, Press [MENU]+[4 TXP][2 SQL], the screen display
Press [MENU] to enter, Press[UP]/[DOWN] to select the need times then Press [MENU] to confirm, and Press
[EXIT] back to standby.
The radio have ANI code transmission delay time is 100~3000 milliseconds, divide into 30levels, each level is 100
milliseconds.
ANI code transmission mode (PTT-ID) ---Menu 43
Tips:
The repeater system for starting the Single tone pulse frequency, some repeater need one to activate, if the
repeater starting, not need it to activate, Optional pulse signal including 1750Hz,2100Hz,1000Hz,1450Hz.
ALERT
PTT-DLY
40
Notice:
Channel scanning group A only can working in area A.
PTT-ID
RING
SCG-A
In the standby, Press [MENU]+[4 TXP][3 SAVE], the screen display
Press [MENU] to enter, Press [UP]/ [DOWN] to select the need mode then Press [MENU] to confirm, and Press
[EXIT] back to standby states.
The radio have 3 ID code transmission mode: BOT(Beginning), EOT(Ending), BOTH.
Ringing Time setting (RING)---Menu 44
In the standby, Press [MENU]+[4 TXP][4 TXP], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select the need time then Press [MENU] to confirm, and Press [EXIT]
back to standby.
The radio have 10 seconds of ringing time, divide 10 levels, each level 1 seconds. OFF: close the function.
Scanning channel group A (SCG-A)---Menu 45
Scanning group is a set of radio which can be grouped by writing data channels, and specify the group of channel
scanning, scanning the channel only for this group of channels.
Scanning group : All full channels, and 1-10 scanning group.
In the standby, Press [MENU]+[4 TXP][5 ROGER], the screen display
Press [UP]/[DOWN] to select then Press [MENU] to confirm, and Press [EXIT] back to standby.