41
Notice:
Scanning channels group B only can working in area B.
SCG-B
RPT-TONE
Scanning channel group B(SCG-B)---Menu 46
Scanning group is a set of radio which can be grouped by writing data channels, and specify the group of channel
scanning, scanning the channel only for this group of channels.
Scanning group: All full channels, and 1-10 scanning group.
Under the standby states, Press [MENU]+[4 TXP][6TOT], the screen display
Press [UP]/[DOWN] to select then Press [MENU] to confirm, and Press [EXIT] back to standby.
Repeater Prompt Tone switch setting (RPT--TONE)---Menu 47
In the standby, Press[MENU]+[4 TXP][7 VOX], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select the desired parameter then Press [MENU] to confirm, and
Press [EXIT] back to standby states.
ON: Turn on the function
OFF: Turn off the function
CDCSS/DCS scanning save type setting (SC-QT)---Menu 48
42
SC-QT
Notice:
TX: Main frequency transmitting, turn off sub - frequency when receiving.
Rx: Main frequency receiving, turn off sub-frequency when receiving.
TX/RX: Main frequency transmitting/receiving, turn off sub-frequency when receiving.
The radio is scanning QT, When scanning to the other side for them, Have 3 optional type to saving:
1. Saving as receiving and transmitting QT (ALL).
2. Saving as transmitting QT (ENCODER).
3. Saving as receiving QT (DECODER).
In the standby, Press[MENU]+[4 TXP][8W/N], the screen display
Press [UP]/[DOWN] to select then Press[MENU] to confirm, and Press [EXIT] back to standby.
Sub-Frequency Mute setting---Menu 49
Mute function is a very useful feature, especially in the dual frequency receiver is more useful.
In the standby, Press [MENU]+, [4 TXP][9 VOICE] the screen display
Press [MENU] to enter, Press [UP]/ [DOWN] to select the desired parameter then Press [MENU] to confirm, and
Press [EXIT] back to standby.
Off: close the function
SMUTESET
To Next Page
Loading...
