Retevis RT69 - Page 23

43
Call code setting (CALLCODE)---Menu 50
In the standby, Press [MENU]+[5 ROGER][0], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select the desired call code then Press [MENU] to confirm , and
Press [EXIT] back to standby.
The radio have 001-100 group call code available to select, this can program by software.
Reset setting (RESET) ---Menu 51
The parameter of reset (VFO): Will reset all functional setting and renew factory default parameter of function
setting, but not resetting the parameter of channels.
The parameter of reset (ALL): Will reset all functional setting and the parameter of all channels, and renew factory
default of function.
In the standby, Press[MENU]+[5 ROGER][3 SAVE], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select the desired the parameter then Press [MENU] to confirm, the
screen display
BACKLIGHT ---Menu 52
In the standby, Press [MENU]+[5 ROGER][2 SQL], the screen display
Press [MENU] to enter, Press [UP]/[DOWN] to select the desired the parameter then Press [MENU] to confirm, the
screen display.
CALLCODE
RESET
Please wait
BACKLIGHT
44
NIGHTMODE
GPS
Select screen light brightness: 01-05 level.
NIGHT MODE ---Menu 53
In the standby, Press [MENU]+[5 ROGER][3 SAVE], the screen display
Press [MENU] to enter, Press [UP]/ DOWN] to select the desired the parameter then Press [MENU] to confirm,
and Press [EXIT] back to standby.
After open IGHT mode, all of screen is dark, back to bright color when close the function.
GPS setting (GPS) ---Menu 54
In the standby, Press [MENU]+[5 ROGER][4 TXP] the screen display
Press [MENU] to enter, Press [UP]/ DOWN] to select the desired the parameter, then Press [EXIT] can measure
the distance between you and your partner, and Press [MENU] to confirm, and Press [EXIT] back to standby.
If you open the GPS module, even if it is not in the GPS mode, it will not stop the GPS module. If the GPS module
does not stop, there is a GPS logo on the right side of the screen.
ADJ-TIME---Menu 55
In the standby,press[MENU]+[5 ROGER][5 ROGER] the screen display
Press[MENU]to enter,press[UP]/[DOWN]to select the desired the parameter then press[MENU]to confirm,and press
[EXIT]back to standby.
ADJ-TIME