Rev-A-Shelf 5707 - Step 7: Bracket and Gas Spring Installation; Vertical Adjustment Procedure

Customer Service: 800-626-1126 | rev-a-shelf.com
6
Locate the (4) pre-tapped holes on
the Swivel Frame. With the knobs
facing outward, attach the Top
Bracket and the Bottom Bracket to
the Swivel Frame using (4) M4x6
Flat Head Screws.
NOTE: Top Bracket is attached
to the uppermost holes on the
Swivel Frame.
With the thinner portion of the
Gas Spring pointing down, snap
the Gas Spring into position using
the knobs on the Top and Bottom
Brackets (See Fig. 7).
NOTE: Ensure the thinner
portion of the Gas Spring is
pointing down.
Cycle the unit a few times. If the
guide channel is not functioning
efciently, vertical adjustments
can be made by loosening the
(4) fasteners at the top and
bottom. Securely re-tighten once
adjustments have been made
(See Fig. 7B).
STEP 7
VERITCAL ADJUSTMENT
Left Side
Figure 7
Figure 7B
Right Side