Reverie 8Q - User Manual

Questions and Answers

J
John ParkJul 27, 2025
What to do if no features of my Reverie Indoor Furnishing 8Q adjustable foundation activate?
- B
  Brittany BaldwinJul 27, 2025
  If no features of your Reverie Indoor Furnishing 8Q adjustable foundation are working, here are a few things to try: * Program the remote control. See the Remote Control Guide that came with your product for instructions. * Unplug the power cord, wait 45 seconds, and then plug it back in to reset the electronic components. * Check your electrical service breaker box to ensure the circuit breaker hasn't tripped. * Test the electrical outlet by plugging in another working appliance to see if the outlet or surge protection device is defective.
T
tasha40Aug 1, 2025
What to do if the head or foot of my Reverie 8Q Indoor Furnishing elevates but won't return to flat?
- C
  csanchezAug 1, 2025
  If the head or foot section of your Reverie Indoor Furnishing elevates but won't return to the flat position: * Elevate the bed and check for, and remove, any obstructions. * Make sure there's a 1.5” (38.1mm) to 2” (50.8mm) distance between the headboard brackets and the mattress. Adjust if needed, as the head section may be too close to the wall.
M
Matthew WilsonAug 6, 2025
What to do if my Reverie 8Q Indoor Furnishing remote control LED is on but the bed won't activate?
- L
  Lisa HillAug 6, 2025
  If the remote control LED on your Reverie Indoor Furnishing illuminates but doesn't activate the bed, make sure the power cord is plugged into a working, grounded electrical outlet. It's recommended to use a grounded, electrical surge protection device. Test the outlet by plugging in another working appliance.
S
Samuel MckenzieAug 11, 2025
Why is there interference when using the head or foot lift on my Reverie 8Q?
- D
  davidgilbertAug 11, 2025
  If you experience minor interference during the head or foot lift function of your Reverie Indoor Furnishing, try these steps: 1. Check and replace the remote batteries if needed. 2. Ensure you're following the motor's duty cycle: do not operate for more than three minutes within a thirty-minute period (approximately 10% duty cycle). 3. Press the lift buttons squarely and accurately. The remote may be experiencing radio frequency interference from other devices.
D
Daniel AllenAug 16, 2025
How to reduce excessive massage motor noise in my Reverie Indoor Furnishing?
- R
  Ronald Howard DVMAug 16, 2025
  If your Reverie Indoor Furnishing massage motor is making excessive noise, consider these solutions: * If the bed is on a hard surface, place carpet pieces underneath. * Elevate the head or foot section slightly using the hand control to realign the lift/lower mechanisms with the bed support platform. * Ensure the bed isn't against a wall, nightstand, or other object that could cause vibration or noise. * If installed over a bed frame, check that the massage motors aren't causing the bed frame to vibrate. * Verify the headboard attachment hardware is firmly tightened (if used).
B
Brandon AdamsAug 21, 2025
How to fix a Reverie 8Q Indoor Furnishing remote when the LED won't illuminate?
- L
  Laurie FreemanAug 21, 2025
  If the remote control LED on your Reverie Indoor Furnishing doesn't illuminate, replace the batteries in the hand control, making sure they are installed correctly.