Revitive Essential - Page 12

22
23
h Press the power button on the Revitive.
You will hear a beep and the display lights will read
30 minutes.
To turn o Revitive at any time during
operation, press the power button on the Revitive .
i Press the (+) Intensity Control, one time, to
start stimulation.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
j Use an intensity that provides you with strong but
comfortable muscle contraction and note that the
intensity required may vary from day to day.
It is normal to feel tingling or varying sensations in
your muscles.
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the (–)
Intensity Control.
• You can also choose to stop therapy before the
end of the 30 minute session to avoid skin irritation.
You can do this by pressing the power button.
R
R
R
R
R
R
d Attach the ends of the body pads to the body pad
cords.
Press connectors until no gap is between them.
Leaving a gap may cause discomfort.
e Plug the other end of the body pad cord into the
opening on the side of Revitive
f Remove the plastic liner from the body pads, by
peeling it o carefully. Replace the body pads onto the
plastic liner aer use.
g Press the body pads on the area(s) you wish to apply
electrical stimulation, as shown on page 18, gently
pressing the adhesive side against the skin.
R
R
R
R
R
R
R
R
R
R
Instructions for use
2452_IFU06_18063164.indd 23
2452_IFU06_18063164.indd 23
19/05/2021 10:22
19/05/2021 10:22