Revitive RMV - Page 25

25
Problem Possible Cause Solution
No power or lights to
REVITIVE Advanced
when it is switched
on.
AC Adaptor not switched on
at the electrical socket or AC
Adaptor not plugged into device
properly.
Check electrical socket power
is switched on and the AC
Adaptor is plugged into
the device correctly. If still
not working – contact your
authorised dealer.
REVITIVE Advanced is
not vibrating.
REVITIVE Advanced IS NOT
DESIGNED TO VIBRATE.
The IsoRocker is not
"rocking".
It is the muscles in your legs
that cause the "rocking",
THE ISOROCKER IS NOT
MECHANICAL.
The ISOROCKER will only rock
when increased to an intensity
which causes sufficient calf
muscle contraction. It may be
that you cannot comfortably
increase the intensity high
enough until you get used to the
sensation. It is important that
intensity is adjusted to a level
that is comfortable.
The device is too far in front
of you.
Sit with your knees at a 90
degree angle.
The IsoRocker system is not
enabled.
Ensure IsoRocker Disabler is
“flat”, in centre position (see
page 12).
My legs are aching
after treatment.
You may have the intensity
on too high a setting and your
muscles are being overworked.
Leave adequate time after
each treatment to allow the
muscles to recover (just like after
vigorous exercise!). On your
next session start on a lower
setting (where you can feel the
mild electrical stimulation and it
is comfortable) and reduce the
duration until your muscles have
acclimatized to the stimulation.
When using the
IsoRocker on a hard
floor it makes a
tapping noise.
Incorrect positioning of the
device or too high an intensity
level.
Adjust the positioning of the
device or lower the intensity
level to reduce the device
tapping. Alternatively use a
floor mat under the device
to cushion the sound.
For more information including Frequently Asked Questions,
please visit www.revitive.com.au
2296_IFU01_9608705.indd 25 17/07/2015 12:28