• History, reporting, graphing of battery charge graphs
• Battery historical performance trending charts (Capacity History and Cell IR History)
• Quick BumpTag setup (faster data input)
• Quick Manual operation setup (faster data input)
• Replace BumpTag Wizard (migrates history data from old BumpTag to new)
• Remote BumpTag scanning from Android mobile device (NFC support required on mobile device)
• DropBox integration for backup and sync of battery history data across multiple mobile devices
Enabling Battery History Upload to CCS App
Since the BumpTag provides a unique identifier for every battery, all battery operation graphs are
automatically associated to the correct battery ID and cached and uploaded to the CCS app for storage
and analysis – all without any user intervention.
By default, battery history caching is disabled on both the charger and the CCS app.
To enable battery history caching, perform the following steps:
1. On the PowerLab Touch (or Bump Controller), go into Settings -> Feature Controls and select the
checkbox for “Upload Battery History”
This will enable history caching locally on the device and it will notify the CCS app whenever it has
history data available for upload.
2. In the CCS app, go into Setttings for each Device (i.e., PowerLab Touch or Bump Controller) for
which you want to upload history to that particular mobile device. Note that multiple mobile devices
can be used to connect to the same chargers, so history upload can be enabled on some devices, but
not others. For example, you may want to monitor and control your PowerLab Touch from your
mobile phone, but you don’t want your phone to upload battery history because you use your tablet
for uploading, storing, and analyzing battery history.
To Next Page
Loading...
Need help?
General
