Revox B215 User Manual

2.4
Tape
transport
commands
-
The tape can be spooled
forward with the
key trtr
[5]
or back-
ward with the
key <<
t6l
-
An
exact
tape Iocation can be
found
by
holding down the
STOP
key
[3]
while
inching the
tape
forward or backward
by
touching the
corresponding spooling
key
[5]
or
[6]).
-
lf the tape
is rewound to the
start,
the
real-time counter
accu-
racy and, therefore, the
repeatability is very
high. Any tape
lo-
cation
can
be traced
with high
precision.
However, this
is only
valid if the entered cassette
playing
time
corresponds
to the
utilized
cassette.
-
lf a
non-rewound cassette
is inserted, the
momentary
counter
reading
is computed after a few seconds
of
playing
time
and
the current
tape location
is indicated in the display
[1'1]
(how-
ever,
the
repeatability
of
the real-time
counter
is not as accur-
ate as
in the above mentioned
method
in which the cassette
is
first rewound to
the
start).
Note:
The
cassette
recorder automatically switches
to STOP
as soon
as the tape
end is reached.
The transparent
leader tape
is recog-
nized bV an optical
tape sensor. After
fast rewind
(key
<<
16l)
has been
pressed,
the
recorder automatically
searches
the tape
sta
rt
(the
counter
is reset
to
zero). The transport
command
keys
can be
pressed
in any sequence
without
passing
via STOP

Revox B215 Specifications

General

Track System	4-track, 2-channel stereo
Tape Speed	4.76 cm/s
Heads	3 (erase, record, playback)
Signal to Noise Ratio	72dB (Dolby C)
Total Harmonic Distortion	0.8%
Type	Cassette Deck
Frequency Response	20Hz to 20kHz
Tape Type	Type I, Metal
Outputs	Line