REVV Generator 100P MK3 - Page 18

REVV | GENERATOR 100P MK3
18
a CC number & then designate whether it be turned to
on or o. (Consult the external equipment instruction
manual).
The following commands & their CC numbers need
only be sent an ON command (0-63) as they are used
to switch between channels & aggression levels which
cannot be turned o, only changed to a dierent channel
or level, on & o commands sent will produce the same
result.The following 2 commands will switch to the
channel & then toggle through the aggression levels
with each use of the command using the footswitch to
switch to the channel & toggle through the aggression
levels. This command will also respond to an on & o
command with the same result:
Function CC Number Hex value)
Ch. 1 13 - (0x0D)
Ch. 1 wide 14 - (0x0E)
Ch. 2 low Drive 15 - (0x0F)
Ch. 2 med Drive 16 - (0x10)
Ch. 2 high Drive 17 - (0x11)
Ch. 3 low aggression 18 - (0x12)
Ch. 3 med aggression 19 - (0x13)
Ch. 3 high aggression 20 - (0x14)
The following command will switch to the channel &
then toggle through the aggression levels with each
use of the command like using the footswitch to
switch to the channel & toggle through the aggression
levels. This command will also respond to an on & o
command with the same result:
Ch. 3+ aggression toggle 24 – (0x18)
The following commands control functions that are
turned on & o. These functions require an o (0-63)
& on (64-127) command (byte) to be sent with the CC
number to either turn them on or o.
If you are trying to use them & are not getting them
to respond, chances are you are sending the wrong
command byte ( 0-63 is OFF & 64-127 is ON).
(Consult the Peripheral’s instruction manual)
Function CC Number Hex value)
Noise Gate 26 – (0x1A)
Masters 27 – (0x1B)
Fat 28 – (0x1C)
Bright 29 – (0x1D)
Mute 30 – (0x1E)
Reverb 31 – (0x1F)
Pre-Post 33 – (0x21)
Cut 34 – (0x22)
FX Loop 35 – (0x23)
Two Notes Power Amp 36 – (0x24)
Two Notes Reverb 37 – (0x25)
Two Notes Noise Gate 38 – (0x26)
Two Notes Twin Tracker 39 – (0x27)
Two Notes EQ 40 – (0x28)
Two Notes EQ R 41 – (0x29)
Two Notes Mute 42 – (0x2A)