REVV | GENERATOR 100P MK3
3
TABLE OF
CONTENTS
P4 Warranty
P5 Safety Instructions & Warnings
P6 Set up & Power up
FRONT PANEL LAYOUT
P7/10
1 Input
2 Channel One (Clean)
3 Channel Two (Crunch)
4 Channel Three (High Gain)
5 Master Volume Control
6 Depth & Presence
Function Controls
7 Reverb Switch
8 Gate Switch
9 Store Switch
10 Pre-Post Switch
11 Headphone Jack
12 Headphone/XLR Level Control
13 Virtual Cabinet Switch
14 Bluetooth Window
15 Standby & Power Switches
BACK PANEL
P11/13
16 Main Power Connection
17 Main & HT Fuses
18 Bias Test Points
19 Power Tube Fault Fuses
20 XLR Output and Ground Lift
20.1 XLR Output Connectors
21 USB Connector
22 Reverb Level Control
23 Gate Threshold Control
24 Wattage Switch
25 Internal Load Switch
26 FX Loop Send and Return Jacks
27 Cabinet Lighting
28 Foot Switch Connection
29 MIDI Connections
30 Impedance & Speaker Jack
TUBES AND BIAS
P14/15
31 Power Tubes
32 Power Tube Sockets
33 Preamp Tubes
34 Power Tube Bias
35 Setting The Bias
36 Bias Chart
MIDI
P16/18
37 Setup
38 OMNI Mode
39 MIDI Channel Setting
40 MIDI Program Change
41 MIDI Controllable Functions
42 Continuous Controller (CC)
TORPEDO REMOTE/LOAD
P19
43 Bluetooth Connection
44 Troubleshooting
45 Internal Reactive Load
SETTINGS & SAVING CABINETS
P20/21
46 Front Panel/Cab Lighting On/O
47 Saving Global/Masters
48 Saving A Digital Cab To A Bank
49 Saving A Digital Cab To A Channel
50 Disable/Enable Speaker Cab
51 Factory Reset
FOOT CONTROLLER
P22/23
52 Hook up
53 Control Mode
54 Preset Mode
55 To Save A Preset To A Bank
56 Foot Controller Reset
57 Foot Controller Mute
To Next Page
Loading...
