REVV | GENERATOR 100P MK3
6
SETUP &
POWER UP
It is very important to place the amplifier in a dry
location that provides 4-6” of space between the rear
of the amplifier and anything in the area that has been
designated for the amplifier. Tubes produce heat, and
anything flammable should be kept away. Verify that the
top heat vent is free from obstruction so that the heat
produced by the tubes can escape from the interior of
the amplifier. Now have a quick look at the tubes and
make sure they are all seated in their sockets. Look
good? We are ready to move on!
First, make sure that the power and standby switches
are in the o (down) positions. Connect the amplifier
to a speaker cabinet using a good quality speaker
cable and set the impedance switch to the required
impedance setting (See 3.5). Next, connect the AC
power cord to the amplifier Mains connector on the
rear of the amplifier and then to an AC outlet.
At this point, all other peripherals can be connected to
the amplifier as well:
Note: A good quality, shielded instrument cable is
recommended for guitar input as well as FX loop
connections to prevent unwanted noise. Cables can
color the sound of a guitar’s signal, and sometimes
trying dierent cable lengths, can provide the desired
sound.
Once all your connections are made, move the power
switch to the On position and give the tubes at least one
minute to warm up. Now is a great time to begin setting
all controls while we wait. We recommend setting the
master volume and gain controls to the lowest setting
or zero (fully counterclockwise) and all treble, mid, and
bass controls to the 12 o’clock positions to begin. Set
the standby switch to the ON (up) position and you are
ready to begin exploring!
Note: Upon power-up, you will have noticed that the
buttons and clip LED all illuminate solid Red. This is the
startup sequence of the amplifier. After a few seconds,
the amplifier will complete the startup sequence and
load up either Channel 1 (default) or your favorite saved
amp setting.
• FX Loop
• Guitar & Shielded
Cable
• MIDI
• XLR
• USB
• Revv Cabinet Lighting
• Headphones
• Revv Foot Controller
To Next Page
Loading...
