The device is configured with a media streaming rearview camera that provides
clear traffic view behind the car. To obtain clearer and more intuitive images, it is
recommended to mount the camera above the license plate (as shown by option B).
Note:
Due to unstable voltages caused by starting the car engine, a voltage fluctuation in
some vehicles may be especially obvious. If a flashing screen or some other
unforeseeable operating problem occurs when you start the engine, it is
recommended to unplug the device from the charger before starting the engine, and
then reconnect it after the engine is running.
Note:
The red wire connects to the positive end of one of the car’s reverse light.
Make sure that the car charger is energized during use. This is only
required if you want to utilize the auto backup camera feature.
Connect the dash cam to the car charger after installation. Starting the car
engine will start the device. The built-in battery will be charged at the same time.
Instructions for Reverse Trigger Wiring (optional)
3.
III.Turn on the Dash Cam
Red
11
To Next Page
Loading...
