8
Step 6
Power on the Camera and Format the Memory Card
Plug the mini
USB connector
to the dash cam
Route the
power cable
Plug the charger
into the power
outlet or a
cigarette lighter
REC MIC
OK
REC MIC
OK
Place the camera on the mount and carefully route the power cable around
the windshield and tuck it in under the trim.
Power the camera by connecting the charger to the car cigarette lighter
and the camera.
The camera will shut down after 3 seconds when it's disconnect from the
power source and it should begin recording automatically the next time it is
powered on.
To ensure the V1P SE records to your memory card properly and without
error, we strongly recommend you to format the card within the camera
when you're using the dash cam for the first time.
Note:
Always remember backup important data stored on the memory card
before formatting.
To Next Page
Loading...
