Co.,Ltd. UV/IR Type Flame Detector RFD-2000X
Document No. Manual-2000X Rev.3
March 2013
- 27 -
4. Operation
The contents of this page are about "Operation". As much as ‘product selection’ or
‘Installation’, the operation is also very important. Though another parts of operation
"Maintenance and Troubleshooting" will be discussed separately in another chapter.
ㆍ Product Inspection
ㆍ Initial Operation of Product
ㆍ Safety Handling
ㆍ Product Testing
4.1 Product Inspection
For the appropriated operation after the installation, the essential information for inspection
will be described below.
4.1.1 Inspection of Installation conditions
If there are any inferior or bad installation, Reinstallation can be recommended. This
minimum inspection can affect to the duration and performance of the products.
ㆍ Product Fixing Conditions
ㆍ Inspection of Product Assembly Conditions (Internal Wiring and Joins)
ㆍ Installation height and angle of different products are vary accordingly.
ㆍ The conditions of product after combination with others product.
(Explosive-proof and water proof, other electrical conditions )
4.2 Initial Operation of Product
The product operation will be explained below under the assumption that all the required
wiring, such as main power supply(24VDC) or signals is connected properly.
To Next Page
Loading...