RF-Star RF-43UP - Soldering and Reflow Condition; Table 6. Temperature Table of Soldering and Reflow

RF-43UP
www.szrfstar.com V1.3 - Jan., 2020
Shenzhen RF-star Technology Co., Ltd. Page 31 of 34
1. According to the anti-static measures, bare hands are not allowed to touch modules.
2. Modules must be placed in anti- static areas.
3. Take the anti-static circuitry (when inputting HV or VHF) into consideration in product design.
Static may result in the degradation in performance of module, even causing the failure.
8.4 Soldering and Reflow Condition
1. Heating method: Conventional Convection or IR/convection.
2. Solder paste composition: Sn96.5 / Ag3.0 / Cu0.5
3. Allowable reflow soldering times: 2 times based on the following reflow soldering profile.
4. Temperature profile: Reflow soldering shall be done according to the following temperature profile.
5. Peak temperature: 245 ℃.
Table 6. Temperature Table of Soldering and Reflow
Profile Feature
Sn-Pb Assembly
Pb-Free Assembly
Solder Paste
Sn63 / Pb37
Sn96.5 / Ag3.0 / Cu0.5
Min. Preheating Temperature (T
min
)
100 ℃
150 ℃
Max. Preheating Temperature (T
max
)
150 ℃
200 ℃
Preheating Time (T
min
to T
max
) (t
1
)
60 s ~ 120 s
60 s ~ 120 s
Average Ascend Rate (T
max
to T
p
)
Max. 3 ℃/s
Max. 3 ℃/s
Liquid Temperature (T
L
)
183 ℃
217 ℃
Time above Liquidus (t
L
)
60 s ~ 90 s
30 s ~ 90 s
Peak Temperature (T
p
)
220 ℃ ~ 235 ℃
230 ℃ ~ 250 ℃
Average Descend Rate (T
p
to T
max
)
Max. 6 ℃/s
Max. 6 ℃/s
Time from 25 ℃ to Peak Temperature (t
2
)
Max. 6 minutes
Max. 8 minutes
Time of Soldering Zone (t
P
)
20±10 s
20±10 s