Rheem 627 series User Manual

TEMPERATURE CONTROL – DELUXE
33
5. Close the front panel on the Deluxe controller.
6. Turn on the Bath Fill mode
 Press the BATH FILL button.
On all Deluxe controllers:
 The BATH FILL operating light will glow.
 The bath fill temperature setting will appear on
the temperature display panel.
 The bath fill water volume will appear on the
bath fill water volume display panel.
 The bath fill indicator light will glow.
7. Open the hot tap.
The operating light will glow on all Deluxe controllers.
Measurement of the water flow at the water heater will
commence when the hot tap is opened.
When the set volume of water has passed through the
water heater:
 Water flow from the hot tap will cease.
 The operating light will go out.
 The bath fill water volume display panel will show
0 litres.
 The temperature display will go blank.
 The BATH FILL operating light will commence to
flash
 The voice prompt will sound;
“the bath is ready, please turn off the hot water tap
and press the BATH FILL button to finish”
8. Close the hot tap.
9. Turn off the Bath Fill mode
 Press the BATH FILL button.
The BATH FILL operating light and bath fill indicator
light will go out.
The bath fill water volume display will go blank.
Note: If the hot tap has not been turned off, the
voice prompt will sound;
“please ensure the bath hot water tap is turned off”
Rheem
BATH (l)
40
°C
120
ACTIVE
ON/OFF
BATH FILL
“please set bath water volume
and bath temperature, then
open the hot water tap”
BATH FILL
BATH (l)
40
°C
120
ACTIVE
ON/OFF
BATH FILL
BATH (l)
40
°C
120
ACTIVE
ON/OFF
“the bath is ready,
please turn off the hot water tap
and press the
BATH FILL button to finish”
BATH FILL
BATH (l)
40
°C
0
ACTIVE
ON/OFF
BATH FILL
BATH (l)
40
°C
0
ACTIVE
ON/OFF
“please ensure the bath hot
water tap is turned off”
BATH (l)
40
°C
0
ACTIVE
ON/OFF
BATH FILL

Rheem 627 series Specifications

General

Brand	Rheem
Model	627 series
Category	Water Heater
Language	English