INSTALLATION
8
TO TURN OFF THE WATER HEATER
To turn off the water heater:
Switch off the electrical supply at the isolating switch to the water heater.
Close the cold water isolation valve at the inlet to the water heater.
Notes
The freeze protection system will be rendered inoperable if electrical
power is not available at the water heater.
Damage caused by freezing due to the unavailability of power at the water
heater is not covered by the Rheem warranty.
Refer to “Warranty Note” on page 40.
If the power has been switched off to the water heater and there is a risk of
freezing, then it is necessary to drain the water heater.
Refer to “Draining the Water Heater” in the Owner‟s Guide and Installation
Instructions supplied with the heat pump storage tank.
VICTORIAN CUSTOMERS
Notice to Victorian Customers from the Victorian Plumbing Industry
Commission. This water heater must be installed by a licensed person as
required by the Victorian Building Act 1993.
Only a licensed person will give you a Compliance Certificate, showing that the
work complies with all the relevant Standards. Only a licensed person will have
insurance protecting their workmanship for 6 years. Make sure you use a
licensed person to install this water heater and ask for your Compliance
Certificate.
To Next Page
Loading...
Need help?
General