Need help?Do you have a question about the Rheem MPi Series and is the answer not in the manual?
Requirements for installing the water heater by qualified persons and in compliance with codes.
Specifies the intended use of the water heater in domestic dwellings.
Describes the two main components shipped separately for assembly.
Requirements for installing a safe tray to prevent property damage from leaks.
Explains the freeze protection system and its operation.
Details pressure requirements and limitations for the mains water supply.
Discusses requirements for water supply from a tank, including pressure.
Instructions for fitting and routing the condensate drain line.
Guidelines for refrigerant recovery at the end of the water heater's service life.
Steps to safely turn off the water heater by disconnecting power and water.
Specific notice for Victorian customers regarding licensed installation.
Illustrates a typical outdoor installation setup with key connection points.
Describes the two main components and their assembly at the installation site.
Details handling and mounting of the heat pump module component.
Explains the storage tank's design for receiving the heat pump module.
Lists components supplied in kits for installing the heat pump module and storage tank.
Outlines the step-by-step process for assembling the heat pump module and storage tank.
Specifies acceptable insulation resistance test results for the water heater.
Emphasizes that all electrical work must be done by a qualified person.
Procedures for filling the water heater and turning on the electrical supply.
Explains the green and red LEDs used for monitoring operation and faults.
Details potential fault conditions indicated by LED status and troubleshooting steps.
Procedure to reset the system and override the start delay.
Advises on potential effects of changing water supply types on the heater.
Explains the saturation index and its impact on warranty for corrosive or scaling water.
Details warranty exclusions related to high chloride levels and low pH.
Outlines warranty terms, exclusions like installation issues, and consequential loss.
To Next Page
General