To Next PageTo Next Page
Need help?Do you have a question about the Rheem P16 Series and is the answer not in the manual?
General| SEER | Up to 16 |
|---|---|
| Refrigerant | R-410A |
| Voltage | 208/230V |
| Phase | 1 |
| HSPF | 9.0 |
Key safety precautions for installation and operation.
Procedures for leak testing the system and insulating the vapor line.
Instructions for running low-voltage control wiring and required components.
Instructions for connecting power wiring and ensuring proper grounding of the unit.
Essential checks before starting the unit, including crankcase heater energization.
Detailed steps for evacuating the system and performing final leak detection.
How the defrost control monitors conditions to initiate defrost cycles.
Initial steps for checking system refrigerant charge.
Method for fine-tuning refrigerant charge using subcooling measurements.
Detailed steps for evacuating the system to remove air and moisture.
Verifying system integrity for leaks after evacuation and repair.
Diagnostic flowchart for electrical issues when the unit is not running or cooling.
Detailed schematic showing electrical connections for the heat pump system.
Visual representation of the heat pump's electrical connections and components.
Importance of airflow, CFM calculations, and measurement techniques.
Flowchart for diagnosing mechanical problems in cooling mode.
Flowchart for diagnosing issues within the defrost system.
Flowchart for diagnosing mechanical problems in heating mode.
Table listing symptoms, causes, and remedies for common system issues.
Guide for troubleshooting compressor overheating symptoms and causes.
Troubleshooting guide for electrical issues affecting compressor operation.
Quick reference table for diagnosing cooling issues based on system indicators.
Quick reference table for diagnosing heating issues based on system indicators.
