57
Heater Name
• Heater name is defined during the heater connection
and setup. It can be changed anytime from the heater
settings.
Exit Heater
• Press X to close heater view and return to heater's list.
Heater Settings
• The 3-dot icon opens heater settings.
• Use this option to edit the parameters defined during
heater configuration.
POOL-SPA page
• Displays the page to control the operation mode and
water temperature target.
ACCESSORIES page
• Displays the page to control heater accessories.
Operation Mode selector
• This 3-button selector can be used to change the
operation mode in the heater.
• Use OFF option to stop heating. In this mode the
heater is operational but is maintained in standby until
mode changes to POOL or SPA.
• Use POOL or SPA mode to set a water temperature
target.
• POOL and SPA mode use an independent temperature
target for each mode.
• Pool mode selector is enabled in Heat/Cool models.
Heater Status
• This display shows the current operational status of
heater.
• No Demand is displayed when the unit is in OFF mode
or when Water Temperature is equal or above the
temperature target.
• Heating is displayed when the unit is heating. In Heat/
Cool models, Cooling is displayed when pool cool or
pool auto is selected and the unit is cooling.
Water Temperature
• The water temperature measured by the heater is
displayed in this field.
Setpoint or Target Temperature
• The water temperature setpoint display and selector
shows the water temperature target.
• Heater start to heat when Water Temperature is 1
degree Fahrenheit or more, below the setpoint and
operation Mode is POOL or SPA.
• Heat/Cool models, Pool Cool mode: Heater starts to
cool when water temperature is 1F or more above the
setpoint.
• Heat/cool models, Pool Auto mode: Heater starts to
cool when water temperature is above the temperature
setpoint + cooling deadband. Heater start to heat
when Water Temperature is 1 degree Fahrenheit or
more, below the setpoint
Setpoint slider selector
• The setpoint slider can be used to make quick changes
to the water temperature target.
• Selection can be fine-tuned with the [+] and [-] buttons
in the setpoint display and selector.
Pool and Spa size
• The Pool and Spa size displays shows the size
selected in the configuration of the heater when
connected to Raymote.
• These parameters can be updated from the Heater
Settings page.
Pool and Spa estimated Heat up time
• These fields displays an estimated heat up time
based in the provided Pool and Spa size, the current
water temperature, the water target temperature and
ambient temperature.
• Technical restrictions apply to this estimation.
To Next Page
Loading...
