Rheem RP1736HJVXA - 1 Function Settings (for Indoor Unit); Function Settings on Indoor Unit

1. Function settings (For indoor unit)
To adjust the functions of this product according to the installation environment, various types of
function settings are available.
NOTE:
Incorrect settings can cause a product malfunction.
1-1. Function settings on indoor unit
¢
Models: RHMV2421MNACJA, RHMV3021SNACJA,
RHMV3621MNACJA, and RHMV4821SNACJA
By using some components on the PCB, you can change the function settings.
Related components on the PCB and the applicable settings
Component Setting content
DIP switch101
1 Setting change prohibited
2 Setting change prohibited
3 Fan delay setting
 Component location
Components on the indoor unit main PCB used for the function settings are located as shown in
the following figure.
SW101
 DIP switch setting
• Switch 1: Setting change prohibited (SW101)
• Switch 2: Setting change prohibited (SW101)
• Switch 3: Fan delay setting (SW101)
When the indoor unit is stopped while operating in conjunction with auxiliary heater, the indoor
unit fan operation will continue for 1 minute.
Switch 3 Fan delay Factory setting
ON Enabled ♦
OFF Disabled
1-1. Function settings on indoor unit - (05-1) - 1. Function settings (For indoor unit)
FIELD WORKING FIELD WORKING