Rheem RPH Series - Page 26

23
5. Warning: Ensure all the power is switched off to the Rheem Heat Pump unit.
6. Then remove the top casing of the heat pump to reveal the panel where the terminal block is housed
for connecting the Dpi Link controller wires. (As shown below).
Note: Access to this terminal block will vary by model.
7. Once done feed the end of the cable with the exposed wires, through one of the electrical access
holes and cable glands on the unit as shown in (Figure 1). Then into the electrical connection and
terminal block housing as shown in (Figure 2).
Terminal Block Housing
Feed 2 pair
wire through to
here.
Figure 1.
Figure 2.
Figure 3.