RHYTHM P2 - Battery Care and Replacement

Maintenance and Cleaning of P2
27
Intake Filter - part # FI-P201
The intake filter is designed to ensure clean air enters the compressor. To replace the
intake filter:
1. Unscrew the bottom of the pre-filter with a Philips
screwdriver.
2. Lift up the pre-filter from the bottom end, then remove it.
3. Remove the intake filter from the intake chamber.
4. Insert a new intake filter into the chamber;
5. Reinstall the pre filter.
Replacement pre-filters and intake filters can be purchased from
your equipment provider.
Battery Care and Maintenance
The P2 Lithium Ion Battery requires special care to ensure proper performance and
long life. Use only P2 batteries # BA-P200 with your concentrator.
CAUTION
Keep liquids away from batteries.
If batteries become wet, stop use immediately and dispose of
battery properly.
Battery Replacement
1.Press down the latch, and slide the battery out.
2.Insert the new P2 battery by sliding battery into place until the latch returns to the
upper position.