To Next PageTo Next PageWhat to do if RIB Garage Door Opener doesn't open or close?
If the RIB Garage Door Opener doesn't open or close when you press the OPEN, CLOSE, K, or RADIO buttons, the issue might be a faulty safety edge contact or faulty photocells contact with DIP 6 OFF. In this case, fix or replace the contact.
Why my RIB SUPER 3600 Garage Door Opener opens but doesn't close?
If the RIB Garage Door Opener opens but doesn't close after the set time, ensure DIP 3 is set to ON and the K BUTTON is always inserted in automatic functioning mode with DIP 5 OFF. Also, replace the button or switch of the selector switch. If there's a failed edge self-test, check the connections between the electronic board and edge feeder. If you're not using a feeder for edges, make sure DIP 12 is in the OFF position.
How to fix a RIB SUPER 3600 that won't move with K or CLOSE button?
If the RIB Garage Door Opener doesn't move when you activate the K or CLOSE button, it could be that impulse K or CLOSE is always inserted. Inspect and replace any faulty buttons or micro-switches on the selector switch.
What to do if all LEDs are off on my RIB Garage Door Opener?
If all the LEDs are switched off after connecting and supplying voltage to the RIB Garage Door Opener, check the integrity of fuses F1 and F2. If a fuse is interrupted, replace it with one of the correct value: F2 = 5A, F1 = 100mA.
General| Manufacturer | RIB |
|---|---|
| Model | SUPER 3600 |
| Category | Garage Door Opener |
| Lifting Capacity | Up to 100 kg |
| Warranty | 2 years |
| Voltage | 230 V |
| Remote Control | Included |
Emphasizes the importance of following all safety instructions for personal safety.
Presents a comprehensive table of technical specifications for the SUPER 3600.
Details critical checks required on the gate and its movement before installation.
Explains the procedure for manually releasing the gate in case of power failure.
Explains how to adjust the limit switches for proper gate opening and closing.
Lists and describes the function of each terminal connection (J1-J17).
Explains the function of each DIP switch for configuring the control panel.
Details the procedure for programming pedestrian opening times.
Guides on how to program radio codes for total opening.
Provides solutions for common faults encountered with the gate system.
