What to do if the RIB AA33694 doesn't open or close with K and RADIO buttons?
If your RIB Garage Door Opener doesn't open or close when you use the K and RADIO buttons, the issue might be a faulty safety edge contact or faulty photocells contact with DIP 4 OFF. You should fix or replace the faulty contact to resolve this.
Why does my RIB AA33694 Garage Door Opener open but not close after the set time?
If your RIB Garage Door Opener opens but doesn't close after the set time, ensure that DIP 3 is set to ON. Also, make sure the K BUTTON is always inserted in automatic functioning mode (DIP 6 OFF). If the issue persists, replace the button or switch of the selector switch. Check the connections between the electronic board and edge feeder. If you're not using a feeder for edges, DIP 10 must be at the OFF position.
How to fix a RIB AA33694 Garage Door Opener motor that opens and closes slowly with no strength?
If your RIB Garage Door Opener motor opens and closes but lacks strength and moves slowly, check the TORQUE and LOW-SPEED adjustment trimmers.
Why is the slowing phase not working on my RIB AA33694?
If the slowing phase isn't working on your RIB Garage Door Opener, make sure DIP 8 is in the OFF position to enable slowing. You may need to relearn the times through procedure from DIP 2. Also, check the LOW-SPEED adjustment trimmer.
What to do if the RIB AA33694 gate does not move when activating the K button?
If your RIB Garage Door Opener gate doesn't move when you press the K button, the impulse K might be always inserted. Check and replace any faulty buttons or micro-switches of the selector switch.
How to troubleshoot all LEDs being off on a RIB AA33694 Garage Door Opener?
If all the LEDs are off after connecting and supplying voltage to your RIB Garage Door Opener, check the integrity of fuses F1 and F2. If a fuse is interrupted, replace it with one of the correct value: F2 = 5A, F1 = 100mA.
General| Input Voltage | 120 VAC |
|---|---|
| Relay Output | SPDT |
| Voltage | 120 VAC |
| Current Rating | 10A |
| Contact Type | SPDT |
| Mounting Type | DIN Rail |
| Contact Ratings | 10A @ 120V AC |
| Operating Temperature | -30 to 140° F |
To Next Page
