BCS-160User Manual V1.6
33
/
57
Fig.38
After setting, press ENTER key to save. Press ESC will quit from the
interface.
8.5.3 Buzzer setting
Under Fig.36 interface to choose item 3. Buzzer and then press ENTER key
to come into the following setting interface, shown as Fig.39:
Fig.39
By pressing or key to set the buzzer function ON/OFF, then press
ENTER key to save. Press ESC will quit from the interface.
The default setting is buzzer enable.
8.5.4 Start way setting
Under Fig.36 interface to choose item 4. Auto/Manual and then press ENTER
key to come into the following setting interface, shown as Fig.40:
To Next Page
