Basic Procedure
21
2
Job Preset
You can make settings for the next
copy job while copying is in progress.
If a long copy job is in progress and
you do not want to wait for it to fin-
ish, you can use this function to make
settings for the next copy job in ad-
vance. When the current copy job fin-
ishes, the next job starts
automatically.
A Press [Next Job] when "Copying"
appears.
B Make settings for the next copy
job.
C Place the originals in the ADF,
and then press the {Start} key.
All originals are scanned.
D Press [To “Printing”].
The initial copy display appears.
Following the current copy job, the
next job starts automatically.
Note
❒ You can switch the display to
the current copy job by pressing
[To “Printing”]. You can switch
the display to the preset job by
pressing [To “Reserving”].
RuC4_AE_Copy-F_FM_forPaper.book Page 21 Thursday, April 14, 2005 1:21 PM
To Next Page
Loading...
