Troubleshooting
149
8
Troubleshooting
Error & Status Messages on the Display Panel
This section describes the principal messages that appear on the panel display.
If a message not described here appears, act according to the message.
Reference
Before turning the main power off, see “Turning On the Power”, General Set-
tings Guide.
❖ Status messages
❖ Alert messages
Message Status
Hex Dump Mode In the Hex Dump mode, the machine receives data in hexadec-
imal format. Turn off the machine after printing, and then turn
back on.
Offline The machine is offline. To start printing, switch the machine
online by pressing [Online] on the display panel.
Please wait. The machine is preparing the development unit. Wait a while.
Printing... The machine is printing. Wait a while.
Ready This is the default ready message. The machine is ready for
use. No action is required.
Resetting job... The machine is resetting the print job. Wait until “Ready” ap-
pears on the display panel.
Setting change... The machine is setting changing. Wait a while.
Waiting... The machine is waiting for the next data to print. Wait a while.
Messages/Second messages Causes Solutions
Authentication has failed. The login user name or pass-
word entered is incorrect.
The machine currently cannot
perform authentication.
Check your login user name
and password.
Consult an administrator.
Ethernet board has a prob-
lem.
An error has occurred in the
Ethernet board.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
HDD has a problem. An error has occurred in the
hard disk drive.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
To Next Page
Loading...
